1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Need help on auto level software

Discussion in 'Software' started by Lance Weston, Jul 11, 2022.

  1. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    578
    Likes Received:
    193
    I have noticed an area of poor performance in the auto level sequence. The G29 command goes through multiple measurements of bed to IR board height. The coded turns the steppers off then on on each measurement. That means it loses the micro stepping height. I have looked through the code and have been unable to find it. It must apply to all Robo machines.

    I need someone facile with the code to find out where the stepper is turned is turned off so it may remain on through the whole test and maintain the micro stepping info.
     
    #1 Lance Weston, Jul 11, 2022
    Last edited: Jul 11, 2022
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,657
    Likes Received:
    7,316
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,657
    Likes Received:
    7,316
    They used to have a mailing list, but darned if I can find it :) Scott Lahteine is their lead developer
     
  4. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    578
    Likes Received:
    193
    Thanks for getting back to me. I am not on social media and never will be. It is just too dangerous.
     
    Kenny Day likes this.
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,657
    Likes Received:
    7,316
  6. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    578
    Likes Received:
    193
    I am using Arduino 1.8.9 has anyone upgraded to version 2.0 safely? I doubt that the older versions are supported for bug fixes.
     
  7. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,657
    Likes Received:
    7,316
    I seem to recall some folks discussing going to Marlin 2.x, but I can not remember who.
    since 2.0 is the current label I doubt they will backport fixes, but they may know if one exists.
     

Share This Page