1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

need help with misalignment

Discussion in 'Troubleshooting' started by jaroslav, Apr 28, 2014.

Thread Status:
Not open for further replies.
  1. jaroslav

    jaroslav New Member

    Joined:
    Apr 25, 2014
    Messages:
    2
    Likes Received:
    0
    Hi guys,
    I just started to set my new printer and all prints where badly, misaligned.
    I did some investigation and found that almost all screws in printer are loose. After tightening them up it got better but still prints come misaligned.
    It squashed in Y axis
    I will appreciate any help how to fix this.
    Thank you,
    jaroslav misalignment.jpg
     
    #1 jaroslav, Apr 28, 2014
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Looks like your y-pulley grub screw may still be loose.
     
    #2 Mike Kelly, Apr 28, 2014
  3. Peter Krska

    Peter Krska Active Member

    Joined:
    Nov 30, 2013
    Messages:
    766
    Likes Received:
    229
    Where is this grub screw?

    [​IMG]
    I too have tightened the bolts and y belt and still have issues with alignment. It's meandering.

    [​IMG]


    Sent from my iPhone using Tapatalk
     
    #3 Peter Krska, Apr 28, 2014
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    #4 Mike Kelly, Apr 28, 2014
  5. jaroslav

    jaroslav New Member

    Joined:
    Apr 25, 2014
    Messages:
    2
    Likes Received:
    0
    You right,
    I just found the loose on grub. Trying to fix. Thank you
     
    #5 jaroslav, Apr 28, 2014
Thread Status:
Not open for further replies.

Share This Page