1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved new R1 plus, can's see the voltage switch

Discussion in 'Troubleshooting' started by Mohammed Masri, Jul 31, 2017.

  1. Mohammed Masri

    Mohammed Masri New Member

    Joined:
    Jul 31, 2017
    Messages:
    1
    Likes Received:
    0
    Hello. I just received my printer but I can't power it up because I don't know if I should give it 115V or 230V. Also, the user manual says that there should be a switch at the back where I can set whichever voltage I want to use but it seems like there is no such switch on the printer I got (see the picture). Thank you.
     

    Attached Files:

    #1 Mohammed Masri, Jul 31, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Your power supply has slid out of position.
    It is set by default to 115 (US power) so if that is what you have you should be fine. You can slide the power supply back into position if you want.
     
    #2 mark tomlinson, Jul 31, 2017

Share This Page