1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved New Robo 3D R1 Wire Unplugged?

Discussion in 'Troubleshooting' started by Bill Cutlip, Mar 13, 2015.

  1. Bill Cutlip

    Bill Cutlip New Member

    Joined:
    Mar 13, 2015
    Messages:
    2
    Likes Received:
    0
    Hello. I just received a new Robo 3D R1 printer and there seems to be a wire unplugged on switch on the Z-Axis on the right side of the printer (see picture). The printer seems to be working ok so I'm not sure if this is supposed to be unplugged or not. I tried searching the forums with no luck. Any help would be appreciated. Thanks in advance. unplugged.jpg
     
    #1 Bill Cutlip, Mar 13, 2015
  2. Ben R

    Ben R Active Member

    Joined:
    Nov 21, 2014
    Messages:
    651
    Likes Received:
    89
    It goes on the outer most connection.
    Polarity of the switch doesn't matter.
     
    #2 Ben R, Mar 13, 2015
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Probably popped out during unboxing. Just plug it back in to the outer most connector as ben said
     
    #3 Mike Kelly, Mar 14, 2015
  4. Bill Cutlip

    Bill Cutlip New Member

    Joined:
    Mar 13, 2015
    Messages:
    2
    Likes Received:
    0
    Ok. Thanks.
     
    #4 Bill Cutlip, Mar 14, 2015

Share This Page