1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Not sure if right thread but I need...

Discussion in 'Off Topic' started by Knighrider, Aug 13, 2014.

  1. Jaeson Cardiff

    Jaeson Cardiff Active Member

    Joined:
    Jul 20, 2014
    Messages:
    152
    Likes Received:
    110
    Cheers Mike.

    CleanO2 Carbon Capture Tech
     
  2. Knighrider

    Knighrider New Member

    Joined:
    Aug 11, 2014
    Messages:
    174
    Likes Received:
    34
    Finally got the bottom printed. Wasn't perfect but it will work. The important part was an exact fit. Now just waiting on the top to finish. Can't thank you enough.

    [​IMG]
     
  3. Jaeson Cardiff

    Jaeson Cardiff Active Member

    Joined:
    Jul 20, 2014
    Messages:
    152
    Likes Received:
    110
    that's great. if you need any adjustments let me know. adjusting measurements is pretty simple.

    CleanO2 Carbon Capture Tech
     
    2 people like this.
  4. Knighrider

    Knighrider New Member

    Joined:
    Aug 11, 2014
    Messages:
    174
    Likes Received:
    34
    I made the bottom work. Just needed a scrap piece as a spacer since there was more space than needed under the board. But that could be a good thing since it isn't water tight. It was a tad narrow on the length but I made some minor trimming and got it to fit.

    We will see what changes, if any need to be made to the top when I get it printed. I just wish I could figure out why the first print of the day goes fine, but I have sticking issues after that.
     

Share This Page