1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Nozzle help geeetech A20M

Discussion in 'Troubleshooting' started by littleTrip, Oct 26, 2019.

  1. littleTrip

    littleTrip New Member

    Joined:
    Oct 26, 2019
    Messages:
    17
    Likes Received:
    3
    gotta be firmware im thinking
     
  2. littleTrip

    littleTrip New Member

    Joined:
    Oct 26, 2019
    Messages:
    17
    Likes Received:
    3
    well i put the old Y axis driver thing into the motherboard and the old one works but the new one that came with the board dont so its that little red driver thing on the board that was missed up not sure how to fix it but ill see if there is a way i believe its not getting the power to run the motor
     
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,728
    Likes Received:
    2,328
    this. You fix it by tuning the stepper driver voltage output. If the driver is just bad take one off the old board and see if it works on the new board.
     

Share This Page