1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Octoprint .ini

Discussion in 'England' started by colinbuck, Oct 1, 2018.

  1. colinbuck

    colinbuck New Member

    Joined:
    Mar 17, 2017
    Messages:
    5
    Likes Received:
    0
    Hi guys and girls help needed, I have recently setup octoprint on my robo 3d r1 plus, and it's running well my only issuie is, where do I find the .ini file from, to use with octoprint I normally use matter control for slicing. Thanks
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    19,497
    Likes Received:
    6,510
    Are you sure you are looking for an INI file? Most common settings are in the config.yaml (for octoprint).

    Some docs over here for OctoPrint. http://docs.octoprint.org/en/master/

    If you illuminate us a bit on what you are trying to do we can perhaps point you in the right direction
     
  3. colinbuck

    colinbuck New Member

    Joined:
    Mar 17, 2017
    Messages:
    5
    Likes Received:
    0
    Hi what I'm trying to do is when I'm setting up octoprint initial setup and it asks to select a slicer and .ini file to import my printer settings into octoprint as I use matter control for slicing
    Thanks
     
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    19,497
    Likes Received:
    6,510
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    19,497
    Likes Received:
    6,510
    If you do the slicing with something else (i.e. not Cura) then just upload the GCODE file and let OctoPrint send it off to the printer.
    I use it this way routinely.
     

Share This Page