1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Part splits in half

Discussion in 'Troubleshooting' started by jbigler1986, Feb 21, 2015.

  1. jbigler1986

    jbigler1986 Active Member

    Joined:
    Feb 13, 2015
    Messages:
    534
    Likes Received:
    128
    I was wondering if you guys have a solution to this? I printed 2 parts that are like the picture. I only attached one of them. The part split completely in half. Any suggestions?
     

    Attached Files:

    #1 jbigler1986, Feb 21, 2015
  2. jbigler1986

    jbigler1986 Active Member

    Joined:
    Feb 13, 2015
    Messages:
    534
    Likes Received:
    128
    New picture
     

    Attached Files:

    #2 jbigler1986, Feb 21, 2015
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    1) material?
    2) temp?
    3) speed?

    Usually this happens when layer bonding fails. Which (very generally speaking) is caused by temperature issues.
    With some materials (like ABS) it can be a more drastic form of warp...but far less usual.
     
    #3 mark tomlinson, Feb 21, 2015

Share This Page