1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Print Starting Too Low

Discussion in 'Troubleshooting' started by Gregory Karaoghlanian, Mar 15, 2018.

Thread Status:
Not open for further replies.
  1. Gregory Karaoghlanian

    Gregory Karaoghlanian New Member

    Joined:
    Mar 15, 2018
    Messages:
    11
    Likes Received:
    2
    Hello. I've had my printer for about a year now and have just been putting off this problem. When the printer is done auto leveling it starts by moving to the print area. But it goes too low and rips the tape on the corner. and its really annoying. If anyone knows how to fix this I would really appreciate it. I'm thinking adding a Gcode to the start section in Cura.
     
    #1 Gregory Karaoghlanian, Mar 15, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Adjust your Autoleveling Z offset (the M565 command). That is a start.
    It could also be that there is something that has affected the bed level itself mechanically and the autoleveling the Robo uses stock is far from great. Make sure the bed is as mechanically level as you can . A common problem is a magnet on the glass bottom not seated fully into the socket on the rails.
     
    #2 mark tomlinson, Mar 16, 2018
  3. Gregory Karaoghlanian

    Gregory Karaoghlanian New Member

    Joined:
    Mar 15, 2018
    Messages:
    11
    Likes Received:
    2
    That fixed it thank you.
     
    #3 Gregory Karaoghlanian, Mar 20, 2018
Thread Status:
Not open for further replies.

Share This Page