1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Print stops within first 3 minutes of print.

Discussion in 'Troubleshooting' started by Samk, Oct 13, 2014.

Thread Status:
Not open for further replies.
  1. Samk

    Samk New Member

    Joined:
    Apr 22, 2014
    Messages:
    1
    Likes Received:
    0
    Hello, so my printer never used to do this, but after moving apartments and setting it up again the printer gets about 3 minutes into a print and then stops altogether. There is no error message in Matter Control, it continues showing progress in the print, but the temps start going down once it stops. I opened the Comm terminal to see if that would tell me what was happening, and I got this:
    upload_2014-10-13_11-23-18.png


    I have made sure that my computer isn't putting the usb port to sleep, and the cable is working. I am heating the bed to 112 because I was having alot of issues with prints sticking to the bed, but now im wondering if I am overheating the board.

    ANY HELP APPRECIATED!!
    thanks
     
    #1 Samk, Oct 13, 2014
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    If this is a new(er) printer it is likely that the bed temp is exceeding the firmware limitation and it is a safety stop.
    (unless you modified the firmware)
     
    #2 mark tomlinson, Oct 13, 2014
Thread Status:
Not open for further replies.

Share This Page