1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Printbed won't heat?

Discussion in 'Troubleshooting' started by alex_ncus, Dec 17, 2013.

Thread Status:
Not open for further replies.
  1. alex_ncus

    alex_ncus New Member

    Joined:
    Dec 5, 2013
    Messages:
    4
    Likes Received:
    2
    Hi. Finally got Robo 3D setup with Setup guide. Extruder heats to 210, bed can't seem to break 20 (e ven though it is set to 80 for ABS print). Any ideas or suggestions?
     
    #1 alex_ncus, Dec 17, 2013
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Check your connections. If it's not heating up a cable might have wiggled loose in transit
     
    #2 Mike Kelly, Dec 18, 2013
Thread Status:
Not open for further replies.

Share This Page