1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved printer do not write to table

Discussion in 'Troubleshooting' started by modding, Feb 2, 2015.

Thread Status:
Not open for further replies.
  1. modding

    modding New Member

    Joined:
    Feb 2, 2015
    Messages:
    1
    Likes Received:
    0
    Hello everyone,

    I am new received robo3d printer.
    But, There is a problem, printer do not write to table.
    What am I doing wrong?
    This process gcode is attached.
    Thank you.

     

    Attached Files:

    #1 modding, Feb 2, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    #2 Mike Kelly, Feb 2, 2015
  3. Ben R

    Ben R Active Member

    Joined:
    Nov 21, 2014
    Messages:
    651
    Likes Received:
    89
    That is classic wires not connected/switches not aligned.
    With that paper there it makes me wonder if youre doing a software bed leveling using matter control. Do not do that. Turn off autoleveling. That is not the one youre looking for. Simply G29. No matter control shenanigans.
     
    #3 Ben R, Feb 4, 2015
Thread Status:
Not open for further replies.

Share This Page