Solved Printer Manual Controls No Response

installed all the latest software and drivers and am having trouble with xyz movement controls.
Temperature/fan works just fine no problem. The motors however will not move..
Print run just stalls and nothing happens.. however, the nozzle temp will cool when cancelled, and then heat again if asked to print.

Doesn't move at all.

 

Wonderful bug in Mattercontrol. Install cura or repetier and see if the problem is still happening.

 

Still have the same issue in Printrun, Cura and Repetier (All latest versions) and have the same issue.

 

Did you run a home all first?

 

Both the GCODE and manual control won't respond

 

When you send G28 it doesn't do anything? No errors or "commands waiting"?

 

All it says is SENDING:G28.
M114 works fine, and I can actually give command to send units G28 X## Y## Z##. Then M114 will feed coordinates but other than that no real movement from motors. Is there a board in the undercarriage? I really doubt ALL the motors are fried :/

 

What does M119 say? And both temps read like normal? Are you able to heat up? Could be loose 12v input

 

All fixed, opened up the undercarriage and checked all connections that's all. Thanks alot.