1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Printer not Recieving USB

Discussion in 'The Printer' started by Jose Luis Abad, Feb 9, 2022.

?

Does your 3d Printer allow you to use USBs/Hard Drives?

  1. Yes

    0 vote(s)
    0.0%
  2. No

    100.0%
  3. Working on it

    0 vote(s)
    0.0%
  1. Jose Luis Abad

    Jose Luis Abad New Member

    Joined:
    Feb 9, 2022
    Messages:
    1
    Likes Received:
    0
    Hello,
    I have tried using my USB/Hard Drive on my Robo e3 and it says "USB not recognized" "Please try again later". I tried a few hours later and still didn't work. I was wondering if it's a problem with the 3d printer or if it's just a problem with the USB. ​
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,960
    Likes Received:
    7,344
    Posted in wrong area -- moving to E3 forum
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,960
    Likes Received:
    7,344
    The R2/C2 can do this because they have a Raspberry Pi internally with Linux (which supports mounting external drives).
    The R1/R1+ and likely the E3 do not have Pi internally and the internal control boards do not have an operating sytem.

    I am not certain on the E3 since I never saw one, but @Geof can probably answer that more definitively
     

Share This Page