1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Printer setup

Discussion in 'Technical Support' started by Allen Morrow, Nov 10, 2013.

  1. Allen Morrow

    Allen Morrow New Member

    Joined:
    Sep 8, 2013
    Messages:
    6
    Likes Received:
    3
    When I go through the steps to setup everything goes fine until I click the home all button. Then instead of going to the front left corner it goes to the bottom right corner. Thoughts?
     
    #1 Allen Morrow, Nov 10, 2013
  2. Coby Robo 3D

    Coby Robo 3D Administrator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    75
    Likes Received:
    108
    Allen,

    It seems like your x motor wire has been connected backwards. Take a look at the electronics board underneath your printer and locate the x motor plug. Simply take it out and switch it around and plug it back in. There is an electronics set up video on our youtube page to reference if you are getting confused. Hope this helps!
     
    #2 Coby Robo 3D, Nov 11, 2013

Share This Page