1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Printing two at a time?

Discussion in 'Off Topic' started by Ed Rington, Jan 20, 2023.

  1. Ed Rington

    Ed Rington New Member

    Joined:
    May 12, 2017
    Messages:
    4
    Likes Received:
    0
    I'm using Matter Control with a Robo printer. I want to print 4 identical small objects? Can I instruct the printer to print all of them at once?
     
    #1 Ed Rington, Jan 20, 2023
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Yes, if the slicer supports it. Some allow you to load the same STL multiple times and position each on the bed where you like and then slice and print. I use Simplify3D but I imagine some of the free/open-source ones do this as well. Someone else can probably comment on MatterControl -- I have not used it.
     
    #2 mark tomlinson, Jan 21, 2023

Share This Page