1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Prints are .5mm bigger on the outside and .5mm smaller on the inside cutouts

Discussion in 'Troubleshooting' started by fastslash25, Jun 14, 2015.

  1. fastslash25

    fastslash25 New Member

    Joined:
    May 11, 2015
    Messages:
    15
    Likes Received:
    1
    When I printed a piece I made in 123d it came out to be .5mm smaller gaps then what I specified in the cad and .5mm bigger on the outside. It was also a bit shorter than it should've been on the z axis. Does anyone know how to calibrate my R1 to have closer prints to what I specified in the STL files? Any calibration method I can try?
     
    #1 fastslash25, Jun 14, 2015
  2. Stephen Capistron

    Stephen Capistron Active Member

    Joined:
    Jan 28, 2015
    Messages:
    442
    Likes Received:
    154


    Over extrusion likely. Try calibrating the extruder.
     
    #2 Stephen Capistron, Jun 15, 2015
    Mike Kelly likes this.

Share This Page