Solved Problems with Cura?

Been having lots of problems lately between breakdowns and waiting on parts....But I finally have my printer up and running again but when I try to print using Cura everything is running but the motor for the extruder isn't. If I try running a print using Matter Control it will though (Just havn't had much luck using it compared to Cura). Any suggestions? I am using Cura 15.01

 

Your temperature is probably too low. Flash a firmware here which has it reduced to 170 instead of 195: help.robo3dprinter.com/Wiki/RoBo_3D_Firmware

 

Well I just finished downloading the file and Aduino followed the instructions and uploaded to attempted to run and print and is still doing the same thing....

 

What temp are you printing at

 

210 for hot end and 60 for bed

 

If you enable the pronterfaceUI can you heat things up and tell it to extrude?

 

Yes it does extrude when I tried it when I told it to

 

Watch the log and see if it has errors while printing

 

I have noticed that the stepper motor stays locked when it is running

 

What does that mean?

 

Only thing I see in the window why they printer is running is
< echo:Unknown command: ""

 

If I try to manually turn the gear for extruder that meshes with stepper motor it will not turn

 

When you try and print do you see any errors in the log?

 

No I just tried running a print and the window for the pronterfaceUI where you can control it I didn't see any error messages or anything thing at all except for < echo:Unknown command: "" at the very top

 

Can you upload the gcode you're trying to run

 

Sorry just got home from work this is the G-Code that I am running
;Sliced at: {day} {date} {time}
;Basic settings: Layer height: {layer_height} Walls: {wall_thickness} Fill: {fill_density}
;Print time: {print_time}
;Filament used: {filament_amount}m {filament_weight}g
;Filament cost: {filament_cost}
;M190 S{print_bed_temperature} ;Uncomment to add your own bed temperature line
;M109 S{print_temperature} ;Uncomment to add your own temperature line
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
M107 ;start with the fan off
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
G1 Z15.0 F{travel_speed} ;move the platform down 15mm
G92 E0 ;zero the extruded length
G1 F200 E3 ;extrude 3mm of feed stock
G92 E0 ;zero the extruded length again
G1 F{travel_speed}
;Put printing message on LCD screen
M117 Printing...

 

That's just the startup. Use the save gcode option in the file menu

 

I saved it why running but how do I view it to copy and upload?

 

Why it was running the last attempt in the error log it did have
< echo:Active Extruder: 0

 

Click the Upload file option.