Unresolved R1+Plus prints in the air

Everything looks level. Made a video. Was easier than pictures lol

 

Yup if you look you can clearly see the left side lift up when the carriage moves all the way to the right.

You can adjust this by making the right side a bit higher up. Keep raising it until it stops that behavior

 

ok ill try. Robo3d told me to adjust the offset. So im playing with that too.
Heres one of it trying to print

 

Think i finally got it to work after setting the offset to -0.6 Printing the calibration circle now and sofar so good

 

You should schedule a 1 on 1 appointment with them. How many times did you try adjusting the levelness to be more biased to the right?

Look up into the lid and make sure the smooth rods are inside of the sockets for them.

 

The rods are in the holes in the lid. Been messing with it for a few hours before it started to print on the bed.