1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved R1+ Printer not connecting and showing gibberish

Discussion in 'Troubleshooting' started by JetMang, Mar 12, 2017.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. JetMang

    JetMang New Member

    Joined:
    Dec 26, 2014
    Messages:
    14
    Likes Received:
    1
    Ok, printer is working again! Robo recommended swapping the Z-motor connections on the board which got the motors moving but skipping steps. So, then tuning the voltage a little bit everything started moving well. Thanks all for the help!


    Chris
     
    #21 JetMang, Mar 21, 2017
    mark tomlinson likes this.
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page