1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered R1 Wiring Harness Connections

Discussion in 'Troubleshooting' started by Brett Cook-Snell, Jul 15, 2016.

  1. Brett Cook-Snell

    Brett Cook-Snell New Member

    Joined:
    Jul 15, 2016
    Messages:
    2
    Likes Received:
    0
    i had to disconnect my wiring couplings to get to the extruder to remove a clog and now I don't seem to have them properly connected. Is there a wiring diagram so I know how to reconnect properly?
     
    #1 Brett Cook-Snell, Jul 15, 2016
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Largest wires are the heater. Fan can be diagnosed by shutting off and turning on the parts fan in the slicer. Thermistor Either reads or doesn't :). Smallest diameter wires more often then not. Hotend fan runs the whole time power is on you can check for 12vdc at the harness with the power on.
     
    #2 Geof, Jul 15, 2016
  3. Brett Cook-Snell

    Brett Cook-Snell New Member

    Joined:
    Jul 15, 2016
    Messages:
    2
    Likes Received:
    0
    Using MatterControl, The actual temperature for the bed seems to display, heat, and maintain correctly. The extruder head temp reading stays constant but heats beyond the 210 limit and starts to smoke after I reconnected the larger wires earlier. The fan does not come on regardless of which configuration. The z axis doesn't move up either.
     
    #3 Brett Cook-Snell, Jul 15, 2016

Share This Page