1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Raft Perimeter

Discussion in 'Troubleshooting' started by Lew, Feb 3, 2024.

  1. Lew

    Lew Member

    Joined:
    Dec 15, 2013
    Messages:
    42
    Likes Received:
    9
    Recently, I have seen the raft perimeter not start immediately at the origin point. So when the raft cross-hatching starts it tend to not adhere to the bed. Subsequent layers of the raft curl and may get bumped and the part closest to that corner may curl

    I have not found any way to solve this - perhaps by making two passes of the raft perimeter?

    Any ideas?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,910
    Likes Received:
    7,338
    Hmm, might need a picture.
    Does the GCode preview show this as well or just the actual print?

    Perhaps at least try another slicer.
     

Share This Page