1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Removing nozlle

Discussion in 'Troubleshooting' started by barry ginsberg, Aug 23, 2015.

  1. barry ginsberg

    barry ginsberg New Member

    Joined:
    May 13, 2015
    Messages:
    28
    Likes Received:
    7
    How do you remove the nozzle. Mine is completely clogged. I ordered new ones. Previous discussions talked about using a hex wrench, but the open part of my nozzle is only the cone (picture attached).

    barry

    There was a ton of melted PLA on the boot. When I removed it, the boot came off easily
     

    Attached Files:

    #1 barry ginsberg, Aug 23, 2015
    Last edited: Aug 23, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    -remove the black plastic cover.
    -be careful to note where the thermistor goes. It is held in by the plastic cover
    -now you can see the brass nozzle
    -two wrenches: 1 for the nozzle and one to hold the heat block so it does not turn
     
    #2 mark tomlinson, Aug 23, 2015
  3. barry ginsberg

    barry ginsberg New Member

    Joined:
    May 13, 2015
    Messages:
    28
    Likes Received:
    7
    Thanks Mark. I did that but the clog was higher. See my next post.

    barry
     
    #3 barry ginsberg, Aug 23, 2015

Share This Page