1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Replacing heated bed

Discussion in 'Troubleshooting' started by sofiadragon1979, Jan 11, 2016.

  1. sofiadragon1979

    sofiadragon1979 Member

    Joined:
    Nov 5, 2014
    Messages:
    34
    Likes Received:
    10
    I just got in a new heated bed, and I am wanting to wire it back up but the wiring for the power is different then the one that I had on the old one and it stopped heating up and Robo suggested I get a new one and I did but there are no instructions and I can't quite figure out how to wire up the power end of it because the connectors are a little large for the power plugs that are on the arduino. Any help would be appreciated.
     
    #1 sofiadragon1979, Jan 11, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Pictures would help.
    Specifically of the wires and where you are trying to land them (the RAMPS... not the Arduino)
    It is possible your heater has a heavier gauge wire.
     
    #2 mark tomlinson, Jan 13, 2016

Share This Page