1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Ribbon cable and heat shrink question

Discussion in 'Troubleshooting' started by supercazzola, Sep 23, 2017.

?

Did the heat shrink at the end of your ribbon cable come loose?

  1. yes

    3 vote(s)
    60.0%

  2. no

    2 vote(s)
    40.0%
  1. supercazzola

    supercazzola Active Member

    Joined:
    Jun 1, 2017
    Messages:
    424
    Likes Received:
    111
    Mine became so loose that the weight of the cable leans the thing over. Since I have the clips for the filament tube on it, I think it is causing unnecessary stress and restriction on the filament, contributing to some of the extrusion issues I am seeing.
     
    #1 supercazzola, Sep 23, 2017

Share This Page