1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

ROBO 3D Printer for the part..

Discussion in 'Troubleshooting' started by JunghoKim, Jul 21, 2014.

Thread Status:
Not open for further replies.
  1. JunghoKim

    JunghoKim New Member

    Joined:
    Jul 15, 2014
    Messages:
    9
    Likes Received:
    0
    With the design drawings, and I produced in 3d. Those as designed does not come out. I tried to open the floor. I tried to remove the gear of the Y-axis. There is something to be worried about me. Do you need to screw is stuck in gear in the Y-axis? Photo is one screw 1 as broken gear of the Y-axis.

    사진 (1).JPG 사진.JPG
     
    #1 JunghoKim, Jul 21, 2014
  2. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    I am not sure if I understand you completely but I will give it a shot I think you are asking about the single screw on the yaxis gear I think mine only came with one as well but when putting in on the motor shaft as long as the set screw is lined up with the flat area of the motor shaft when it is tightened it should be very stable and work just fine.

    As I said I am not exactly sure what you are asking so I answered what I could.
     
    #2 tesseract, Jul 21, 2014
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    I agree, one screw is enough as long as you tighten it.
    I added loctite to mine as well because I did not want to have to worry about them again.
    Over a year now and none have worked their way loose again.
     
    #3 mark tomlinson, Jul 22, 2014
  4. JunghoKim

    JunghoKim New Member

    Joined:
    Jul 15, 2014
    Messages:
    9
    Likes Received:
    0
    Thanks, I have solved this problem successfully.
     
    #4 JunghoKim, Jul 22, 2014
Thread Status:
Not open for further replies.

Share This Page