1. 

   Preston12 New Member

   Joined:

   Nov 21, 2015

   Messages:

   7

   Likes Received:

   0

   I recently installed the e3d v6 print head on my Robo 3d r1 and it was working fine at first but now the extruder temp is displayed at 0 and wont go up and the bed only stays at 30. the autocalibration works but the individual axis's don't work in mattercontrol.

    

   #1 Preston12, Nov 21, 2015
2. 

   mark tomlinson ༼ つ ◕_ ◕ ༽つ

   Staff Member

   Joined:

   Feb 21, 2013

   Messages:

   23,914

   Likes Received:

   7,338

   Bad connection to the thermistor or a bad thermistor.
   Make sure it is properly connected to the RAMPS.

    

   #2 mark tomlinson, Nov 22, 2015

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in