1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Robo r1+ hot end fan

Discussion in 'Troubleshooting' started by Jason Bates, Feb 20, 2017.

Thread Status:
Not open for further replies.
  1. Jason Bates

    Jason Bates New Member

    Joined:
    Jan 28, 2016
    Messages:
    7
    Likes Received:
    0
    Well my hot end fan stopped working on me while he of course caused a major clog. I have put in an order for a replacement fan but they are not in Stock. Anyone know a high rpm fan I could get in the meantime to get my printer up and going?

    I tried one off of Amazon. And it wasn't strong enough :(
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,994
    Likes Received:
    7,345
    There are adapters on thingiverse for larger fans (the small one is 30mm) like 40mm or 45mm.
    I don't know of a specific model I could suggest. Perhaps search and see if Noctua or any of the other high quality fans are in that size? Only one I found was 40mmx40mm as well.

    Maybe one like this?

    https://www.amazon.com/30mm-10mm-Quiet-Output-3010/dp/B01FBPQF1Q

    I have not used that specific one, the ones on my other Robo R1+ style printers are E3Ds and the hexagon ones on the C2 are built into the base plate where the hotend mounts and they are like 50mm.
     
Thread Status:
Not open for further replies.

Share This Page