1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Robo R1 Plus Ramps board?

Discussion in 'Troubleshooting' started by Shane Simino, Oct 6, 2017.

  1. Shane Simino

    Shane Simino Member

    Joined:
    Jun 23, 2016
    Messages:
    92
    Likes Received:
    26
    I've got a Robo down for the count. It keeps having issues that started a few months ago. Extruder stepper skipping, temp error. I ended up changing the driver, installing E3Dv6. It ran awhile and now it would run and then have heat error. Then extruder motor started skipping, just no power to turn the motor. I really think my Ramps board is shot, but need some opinion since it's expensive. I had a spare Mega board and swapped that out to rule that out. Reflashed with Robo V2 and now I'm getting Maxtemp bed error. WTH. Opinions and options please!
     
    #1 Shane Simino, Oct 6, 2017
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    seems like something funky is going on, the max-temp is a shorted thermistor reading, either in the ramps, wires or thermistor itself for the bed. Extruder skipping could just be the Extruder stepper driver needs some tuning.
     
    #2 Geof, Oct 6, 2017
  3. Shane Simino

    Shane Simino Member

    Joined:
    Jun 23, 2016
    Messages:
    92
    Likes Received:
    26
    There's so much weirdness with this one machine. I don't get it. One thing after another. It's my unreliable turd. lol
     
    #3 Shane Simino, Oct 6, 2017
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    #4 Geof, Oct 6, 2017

Share This Page