1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partially Solved ROBO R1 PLUS+

Discussion in 'Troubleshooting' started by Jony1986, Jul 1, 2023.

  1. Jony1986

    Jony1986 New Member

    Joined:
    Jul 17, 2022
    Messages:
    9
    Likes Received:
    0
    HOLA HACE TIEMPO SOLUCIONE UN PROBLEMA A MADIAS CON UNO DE LOS DRIVERS Y AHORA UNO DE LOS EJES Z SUBE MAS QUE EL OTRO ALGUNA SOLUCION PARA QUE FUNCIONE CORRECTAMENTE? GRACIAS
     
    #1 Jony1986, Jul 1, 2023
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Con el R1+ hay dos controladores paso a paso, uno para cada varilla roscada en el eje Z. Probablemente necesite reemplazar uno, pero reemplazaría ambos porque no son caros.

    With the R1+ there are two stepper drivers -- one for each threaded rod on the Z axis. You probably need to replace one, but I would replace both because they are not expensive.
     
    #2 mark tomlinson, Jul 2, 2023
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Robo3D R1 +Plus Ramps Board (labeled).jpg
     
    #3 mark tomlinson, Jul 2, 2023
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    #4 mark tomlinson, Jul 2, 2023

Share This Page