1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Robo r2 bed lowering before print

Discussion in 'Troubleshooting' started by Printer007, May 31, 2023.

  1. Printer007

    Printer007 New Member

    Joined:
    May 31, 2023
    Messages:
    8
    Likes Received:
    0
    I just recently had a bad print and had to changed a belt on my Robo r2. Now the printer will lower the bed during the startup of a print. It makes this terrible noise and messes up the z axis. I don't think it's the bed sensor since it lowers fine during wizards and such.

    I have a vid, having trouble posting it though
     
    #1 Printer007, May 31, 2023
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Moved to R2 forum (was in R1+)
    Host the video on an external site and post a link to it.
    If you do not have enough posts to post a link, PM me the link and I will add it.
     
    #2 mark tomlinson, Jun 2, 2023
  3. matthew2023

    matthew2023 New Member

    Joined:
    Jul 31, 2023
    Messages:
    6
    Likes Received:
    1
    I have a vid, having trouble posting it though
     
    #3 matthew2023, Jul 31, 2023
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Post it to a video sharing side and then post the link,
     
    #4 mark tomlinson, Jul 31, 2023

Share This Page