1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Robo3d

Discussion in 'Troubleshooting' started by Tony1971, Oct 9, 2019.

  1. Tony1971

    Tony1971 New Member

    Joined:
    Oct 9, 2019
    Messages:
    2
    Likes Received:
    0
    Printer head is stuck on bed. How do I reset it without breaking anything?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
  3. Tony1971

    Tony1971 New Member

    Joined:
    Oct 9, 2019
    Messages:
    2
    Likes Received:
    0
    It was starting a print job and the we had to stop it with the extruder on the bed. Didn't want to force it up. Just need to figure out how to reset it to the starting position. Sorry if this doesn't make any sense. I am very new at this
     
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    So turn it back on and it should reset itself.
    Reboot the printer essentially and reconnect with your software and tell it to HOME.
     
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #5 mark tomlinson, Oct 11, 2019
    Last edited: Oct 11, 2019

Share This Page