1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved robob r1+ locks up beginning of print

Discussion in 'Troubleshooting' started by eric tobin, Nov 23, 2017.

  1. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    Ok, my machine prints fine with PLA, used to print well with ABS. All of a sudden it has started locking up a few seconds into a print with abs. Used matterslice and slicr3 no change. Need to restart both machine and software after this happens. It will print PLA just fine.
     
    #1 eric tobin, Nov 23, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Look through the GCode console in whichever software you are using for any errors. Look all the way back, not just what shows on the screen Save it to disk if you need to and then use notepad or the like.
     
    #2 mark tomlinson, Nov 23, 2017
  3. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    thank you veryt much, found and am fixing it
     
    #3 eric tobin, Nov 23, 2017

Share This Page