1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer SD3 and XXL Controller parts cooling fan not turning on

Discussion in 'Troubleshooting' started by jasonsummers9, Feb 3, 2018.

  1. jasonsummers9

    jasonsummers9 New Member

    Joined:
    Feb 3, 2018
    Messages:
    2
    Likes Received:
    0
    So I am trying to use an XXL Controller and sd3 slicing software to control my R1+ and I can not for the life of me get the parts cooling fan to come on. I know that the fan works when I use matter control to write file to sd card or via computer hooked to printer. I know that it is supposed to be writing a M106 code in the gfile for the file but I am lost where to go look for this. any help much appreciated.
     
    #1 jasonsummers9, Feb 3, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Make sure the slicer is telling it to turn on in the GCode. Check the settings for the slice.
    That printer is 100% controlled by the slice settings.
     
    #2 mark tomlinson, Feb 4, 2018
  3. jasonsummers9

    jasonsummers9 New Member

    Joined:
    Feb 3, 2018
    Messages:
    2
    Likes Received:
    0
    Mark,

    I am very new to all of this I think I am turning it on. I have included a pic FFF window for cooling is this correct . 1.PNG
    thank you
     
    #3 jasonsummers9, Feb 4, 2018
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Yes, that is correct.
     
    #4 mark tomlinson, Feb 4, 2018

Share This Page