1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

settings

Discussion in 'Troubleshooting' started by Herbert Jackson, Oct 9, 2014.

Thread Status:
Not open for further replies.
  1. Herbert Jackson

    Herbert Jackson New Member

    Joined:
    Oct 9, 2014
    Messages:
    4
    Likes Received:
    0
    1009141852-00.jpg The first print I did came out good. From there on in I have been having problems. (picture enclosed) The finished top layer does not fill in the voids. I have holes over everything. I am using Mattercontrol. Are my settings wrong. using PDA 1009141852-00.jpg
    1009141852-00.jpg I also tired printing this with Simplify 3d software, but the ROBO3d goes to the home position and stops.
     
    #1 Herbert Jackson, Oct 9, 2014
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Try increasing the number of top/bottom fill layers
     
    #2 Mike Kelly, Oct 10, 2014
Thread Status:
Not open for further replies.

Share This Page