1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partially Solved simplify3d "warning:firmware unresponsive. attempting to force continue."

Discussion in 'Troubleshooting' started by nerdtron99, Mar 22, 2015.

  1. nerdtron99

    nerdtron99 New Member

    Joined:
    Mar 14, 2015
    Messages:
    4
    Likes Received:
    0
    ever since i got this message in simplify3d. it won't print anything. not even with MC or repetier host. do i need to re-flash the firmware? if so please instruct me on how to do so.
     
    #1 nerdtron99, Mar 22, 2015
  2. Stephen Capistron

    Stephen Capistron Active Member

    Joined:
    Jan 28, 2015
    Messages:
    442
    Likes Received:
    154
    #2 Stephen Capistron, Mar 22, 2015
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Print from the SD card. This is a USB failure. Also open a ticket with their support folks. It is not a firmware problem.
     
    #3 mark tomlinson, Mar 22, 2015
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    At least mine was not
     
    #4 mark tomlinson, Mar 22, 2015

Share This Page