1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Slice error

Discussion in 'Troubleshooting' started by kogut, Apr 2, 2014.

Thread Status:
Not open for further replies.
  1. kogut

    kogut New Member

    Joined:
    Mar 25, 2014
    Messages:
    7
    Likes Received:
    0
    Hi guys,

    I have my Robo 3D few days, Untill now i have no problems with the printer but I can not print some models such as rod stabilizers. when I throw them to the slicer error pops up "Slice error. Please review your slice settings" I'm using MatterControl software.

    Do you got any ideas what can be reason?

    Regards
    Kogut
     
    #1 kogut, Apr 2, 2014
  2. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    Not a huge MC fan sorryI would suggest trying repetier out
     
    #2 tesseract, Apr 2, 2014
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Which slicer are you using in MC?
    Try the other one or just try repetier or cura as tesseract suggested.

    Heck even kisslicer would be something to test if you are adventure bound.
     
    #3 mark tomlinson, Apr 2, 2014
  4. kogut

    kogut New Member

    Joined:
    Mar 25, 2014
    Messages:
    7
    Likes Received:
    0
    Hi,
    With repetier everything works :) thanx for for help :D
     
    #4 kogut, Apr 5, 2014
Thread Status:
Not open for further replies.

Share This Page