1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Support Materials 101???

Discussion in 'Troubleshooting' started by jdumbaugh, Jan 2, 2014.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. Racegrafix

    Racegrafix Active Member

    Joined:
    Nov 18, 2013
    Messages:
    213
    Likes Received:
    62
    I would just make an arc from the inside area meet up to those points on the side, then you should be able to just trim the side off, and it will be on the inside. If it comes out terrible, present it to her on your middle finger and don't say a word.
     
    #21 Racegrafix, Jan 7, 2014
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page