1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Thermal Couple Detached

Discussion in 'Troubleshooting' started by Randy Merrell, Nov 8, 2014.

Thread Status:
Not open for further replies.
  1. Randy Merrell

    Randy Merrell Member

    Joined:
    Feb 28, 2014
    Messages:
    53
    Likes Received:
    40
    How do I reattach the temp monitor to the extruder?
     
    #1 Randy Merrell, Nov 8, 2014
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    The thermistor? Just (gently) push it back into the hole* in the hotend. You will either need to get
    some Kapton tape to wrap around it to hold it there or use some high-temp RTV/silicon/something.

    *not the hole the filament extrudes from, there should be one on the side near where the nozzle attaches (but in the hotend itself, not the nozzle).
     
    #2 mark tomlinson, Nov 8, 2014
    2 people like this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #3 mark tomlinson, Nov 8, 2014
    2 people like this.
  4. Randy Merrell

    Randy Merrell Member

    Joined:
    Feb 28, 2014
    Messages:
    53
    Likes Received:
    40
    Thanks Mark.
     
    #4 Randy Merrell, Nov 9, 2014
Thread Status:
Not open for further replies.

Share This Page