1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Troubleshooting Trivia - Filament stops extruding.

Discussion in 'Troubleshooting' started by Printed Solid, Apr 11, 2015.

  1. Stephen Capistron

    Stephen Capistron Active Member

    Joined:
    Jan 28, 2015
    Messages:
    442
    Likes Received:
    154
    I'm not sure if robo could have found another fan that was any louder than that little guy. It is painful.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Yes, they are.
     
    Wikid likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Keep a close eye on it. If it is loud then it is probably nearing the death point :)
    Normally they are not very loud (that little one at least).
     

Share This Page