Solved up and down reversed.

Hello,

Yeah i'm back again.. I had my printer replaced via amazon and they sent me the r1 plus. Everything was smooth checked every axis, then i pressed print...... So like anyone i watched to make sure it started ok and it just kept going up and up and up. i watched it stop at the corners as if the print bed was up.

What is strange, is that when i go in and toggle Z manually... + is up - is down.

Please help, this is the 3rd replacement and the only reason i gave another chance is they upgraded me to the plus.

 

Watch this: http://guide.robo3d.com/Guide/Homing+Your+Extruder/7

and schedule a 1 on 1 with a robo technician

 

Ok did what the video showed... You may want to add a pop up showing that if you have the plus there are side tabs and that to adjust them, you need to remove the lid.You also have to push them towards the center of the print bed to set the bolts into their holes. I tried adjust them before posting but figured that they were locked because of the tab things.

Doing a calibration print now. Closing this as resolved.

Thank you.