Unresolved Updated to new Mattercontrol 1.2, now printer won't move

Hey guys,
When I upgraded my R1 autoleveler to the new MatterControl 1.2 version, now it doesn't work. I can't move my printer with the X Y and Z buttons, nor can I pre-heat it. Any ideas?

Thanks!
Steve

 

I am on 1.2 and have no issues. Is your firmware up to date?

 

Does it say your printer is connected. Delete your printer profile and make a new one.

 

It did say my printer is connected. I can turn the fan on, but I don't have the temperature controls nor the axis moves. I recently replaced my thermistor. Could that be the issue?

 

When I try to move X Y Z, I get this error in the terminal:

<-Resend: 1
<-ok
<-ok
<-Error:0
<-: Extruder switched off. MINTEMP triggered !
<-Errorrinter stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
->M105

 

Sounds like one of thermistor line is open. Make sure all the connections are solid and that neither thermistor reads 0C