1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

usb/com problems.

Discussion in 'Troubleshooting' started by Brandon23, Mar 19, 2014.

Thread Status:
Not open for further replies.
  1. Brandon23

    Brandon23 New Member

    Joined:
    Mar 19, 2014
    Messages:
    15
    Likes Received:
    0
    hi I just got my robo today , I have windows 8 and I can't download the required usb driver so that repetier can connect to my robo. can someone please help thanks
     
    #1 Brandon23, Mar 19, 2014
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Simple way is to download and install the Arduino programmer.

    http://arduino.cc/en/main/software

    It will load and install the Arduino driver (which seems to be all the Robo needs).
     
    #2 mark tomlinson, Mar 19, 2014
  3. Brandon23

    Brandon23 New Member

    Joined:
    Mar 19, 2014
    Messages:
    15
    Likes Received:
    0
    Thanks I'm going to try it now
     
    #3 Brandon23, Mar 19, 2014
  4. Brandon23

    Brandon23 New Member

    Joined:
    Mar 19, 2014
    Messages:
    15
    Likes Received:
    0
    Thanks it's working now but I ran into another problem the filament will not extrude. Any body help on this one? Thanks
     
    #4 Brandon23, Mar 20, 2014
  5. SteveC

    SteveC Well-Known Member

    Joined:
    Jun 12, 2013
    Messages:
    894
    Likes Received:
    316
    Hi Brandon, Sure just give us some details.
     
    #5 SteveC, Mar 20, 2014
  6. Brandon23

    Brandon23 New Member

    Joined:
    Mar 19, 2014
    Messages:
    15
    Likes Received:
    0
    Thank but I got it working now I think the filament was bad or something as I changed to another filament and it started to print just fint but thanks anyways
     
    #6 Brandon23, Mar 20, 2014
  7. SteveC

    SteveC Well-Known Member

    Joined:
    Jun 12, 2013
    Messages:
    894
    Likes Received:
    316
    If you go back to that filament try upping the temperature in 5C increments.
     
    #7 SteveC, Mar 20, 2014
  8. Brandon23

    Brandon23 New Member

    Joined:
    Mar 19, 2014
    Messages:
    15
    Likes Received:
    0
    Ok thanks will try sometime soon
     
    #8 Brandon23, Mar 20, 2014
Thread Status:
Not open for further replies.

Share This Page