1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

V2 Bed Buildtak Replacement

Discussion in 'General Questions' started by Shrey, Feb 20, 2018.

  1. drbanks

    drbanks Active Member

    Joined:
    Dec 29, 2017
    Messages:
    140
    Likes Received:
    38
    I think you just inspired me to order one.
     
    Adam Laird likes this.
  2. Adam Laird

    Adam Laird Member

    Joined:
    May 11, 2017
    Messages:
    43
    Likes Received:
    12
    The magnetic base has some cut outs in the corners. I think I read somewhere that they’re supposed to accommodate clips for beds on other printers. The steel plate that the buildtak sticks on is square, and it fits nicely within the bed. There shouldn’t be any exposed adhesive.


    Sent from my iPhone using Tapatalk
     
    supercazzola and Geof like this.
  3. supercazzola

    supercazzola Active Member

    Joined:
    Jun 1, 2017
    Messages:
    338
    Likes Received:
    87
    Thanks


    Sent from my iPhone using Tapatalk Pro
     
  4. Redriche

    Redriche Member

    Joined:
    Jun 7, 2017
    Messages:
    64
    Likes Received:
    15
    Because I didn't think about before submitting the order


    Sent from my iPhone using Tapatalk
     
  5. drbanks

    drbanks Active Member

    Joined:
    Dec 29, 2017
    Messages:
    140
    Likes Received:
    38
    I got a spare plate, some buildtak replacement sheets, and just for S&G got a PEI sheet, which I just stuck onto the spare plate.

    Just started my first print on PEI in the R2, and so far, looking very good.
     

Share This Page