1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved What is going on with my Stepper? Extruder motor studder

Discussion in 'Troubleshooting' started by Curtis Wolfe, Mar 31, 2017.

Thread Status:
Not open for further replies.
  1. Curtis Wolfe

    Curtis Wolfe Active Member

    Joined:
    Feb 21, 2017
    Messages:
    254
    Likes Received:
    78
    I made my first model in 3D builder and printed it out. Turned out great. I switched filaments to start another print. I run back into my printer room to this sound. I tried a different model. Turned the printer off and back on. I print from an SD card. With Cura as the slicer.

    I unloaded the filament, hooked up to Matter Control and enabled cold extrusion. Sent the signal to extrude with the same results.

    I'm thinking broken or loose wire, or perhaps the stepper drivers.




    https://www.facebook.com/video.php?v=10155217187954851



    Help!
     
    #1 Curtis Wolfe, Mar 31, 2017
  2. Curtis Wolfe

    Curtis Wolfe Active Member

    Joined:
    Feb 21, 2017
    Messages:
    254
    Likes Received:
    78
    Fixed. Loose wire on the back of the stepper
     
    #2 Curtis Wolfe, Mar 31, 2017
    Geof likes this.
Thread Status:
Not open for further replies.

Share This Page