1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Why is Slic3r Infilling my holes?

Discussion in 'Troubleshooting' started by TheOneRaven, Mar 15, 2014.

Thread Status:
Not open for further replies.
  1. TheOneRaven

    TheOneRaven New Member

    Joined:
    Mar 6, 2014
    Messages:
    22
    Likes Received:
    0
    #1 TheOneRaven, Mar 15, 2014
  2. SteveC

    SteveC Well-Known Member

    Joined:
    Jun 12, 2013
    Messages:
    894
    Likes Received:
    316
    Are you sure there is no "leftover" interior geometry inside the object? Stray line segments that were not deleted? I have seen Slic3r try do strange things in these situations. What tools are you using? You could run it through the free netfab to clean it up. Most design programs can search for these problems.
     
    #2 SteveC, Mar 15, 2014
  3. Bob64

    Bob64 Member

    Joined:
    Mar 18, 2013
    Messages:
    104
    Likes Received:
    23
    If you've 3d modeled the object, check your normals. Some faces may be reversed.
     
    #3 Bob64, Mar 25, 2014
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Do all the slicers (slic3r, cura, kissliscer, etc) all do this--for this model?
     
    #4 mark tomlinson, Mar 25, 2014
  5. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    I run everything I have even parts I design myself through the netfabb cleanup.
    netfabb basic is free and works very well.
    I believe that could fix teh issue you are having just start doing it early and make it part of your process to run everything through and you will be much happier with the results
     
    #5 tesseract, Mar 25, 2014
Thread Status:
Not open for further replies.

Share This Page