1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Why is this happening:(

Discussion in 'Troubleshooting' started by Monder, Jul 11, 2016.

  1. Monder

    Monder New Member

    Joined:
    Jun 8, 2014
    Messages:
    23
    Likes Received:
    2
    Hi everyone
    The filament won't stick on the bed
    Can anyone help me with good settings for 0.6 nozzle head
    Thanks
     

    Attached Files:

    #1 Monder, Jul 11, 2016
  2. Kevin Robo 3D

    Kevin Robo 3D Guest

    It looks like you have to lower your Z offset a bit
     
    #2 Kevin Robo 3D, Jul 11, 2016
    Lord_Surl likes this.
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Yes id agree. A larger nozzle for me has meant lowering the z offset to get closer to the bed. I also cut my print speed in half when doing the much larger layers. .06 i was ok but if you start jamming up drop the speed
     
    #3 Geof, Jul 11, 2016
  4. Lord_Surl

    Lord_Surl Member

    Joined:
    Aug 20, 2015
    Messages:
    33
    Likes Received:
    2
    As was said above, your z axis height seems to be a bit too high. You can easily edit this in the settings. Just keep decreasing it by small increments until it prints out nicely. Also, make sure you don't lower it too much or you'll run into some nasty clogs.
     
    #4 Lord_Surl, Jul 12, 2016

Share This Page