1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved X home

Discussion in 'Troubleshooting' started by lichaem69, Apr 21, 2016.

  1. lichaem69

    lichaem69 Member

    Joined:
    Apr 15, 2014
    Messages:
    71
    Likes Received:
    8
    So i called robo3d, and the customer service got my new board connected. Now after turning it on, the x does not home. In repetier when i click for the x to go left, the bottom says endstop. The other axis move to their respective home, and i can move the x to the right, but not left or home. The board is the current one on the robo3d website that isn't the r1+ one. Any help would be gratefully appreciated
     
    #1 lichaem69, Apr 21, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Which board? (There are two)
    If this is the RAMPS then it sounds like the X home switch is connected incorrectly (or has a bad connection to the switch).

    Pictures are always helpful. How about one from the top showing the wiring and connections for the endstop?
     
    #2 mark tomlinson, Apr 21, 2016

Share This Page