1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Y Axis misshape part

Discussion in 'Troubleshooting' started by M_Movasat, Jan 5, 2024.

  1. M_Movasat

    M_Movasat New Member

    Joined:
    Dec 25, 2023
    Messages:
    1
    Likes Received:
    0
    my printer keeps messing with the y axis. how do I fix this?
    photo_2024-01-02_15-07-59.jpg photo_2024-01-02_15-07-52.jpg
    I have a robo3d R1
    Using repetier with cura engine
    Using standard robo3d PLA Filament
    I also Tried simplify 3d and slic3r with the same result
    both X and Y belts are moderately tight but the problem is still occuring
    Help please
     
    #1 M_Movasat, Jan 5, 2024
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Have you tried repairing the model?
    That print does not look like it is suffering from an axis shift, it is too consistent.
    Other than the fact that it does not match the model -- it looks like a good print.
    Run it through a tester and see what (if any) corrections are applied.

    Some slicers have test/check options so start there, but there are others you can upload the model to for more testing.

    https://all3dp.com/2/stl-repair-fixer-tool-online-offline/

    If none of those find anything to fix, then upload the model somewhere and one of us can take a look at it.
     
    #2 mark tomlinson, Jan 8, 2024
    M_Movasat likes this.

Share This Page