1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Z Axis Not Homing

Discussion in 'Troubleshooting' started by Brett Moser, Nov 17, 2017.

  1. Brett Moser

    Brett Moser New Member

    Joined:
    Nov 17, 2017
    Messages:
    1
    Likes Received:
    0
    Hey guys. I just got a r1 plus from a friend. When I try to autohome the x and y work great but z stays in the same place. I located the z end switches and they are attached and touching the xaxis. So I'm assuming it just thinks its always home. I don't have any reference to go off and was hoping you could help
     
    #1 Brett Moser, Nov 17, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    #2 mark tomlinson, Nov 17, 2017
    Brett Moser likes this.

Share This Page